Miller has just released their new Millermatic Reach . This is a wire feeder that hooks up to the Millermatic 212, 251, 252 350 and 350p mig welders . It allows you to extend your welding capabilities with this feeder from 22' to 43' . Machine does not come with a mig gun , so you have to use one that is compatable with your amperage requirements.Use the Reach with your Millermatic 212 Auto-Set, 252, or 350/350P to extend your work area or to create a dual feeder, avoiding downtime from changing wire spools.
Extend your Millermatic work area up to 40 ft! No more moving the machine and pulling primary power cables around the shop.
Use as a dual feeder option! Keep one wire in the machine and a different wire in the feeder. No more downtime changing spools and drive rolls.
Auto-Gun Detect™ — when connected to a Millermatic 252 or 350P, simply pull thetrigger on either gun and the Millermaticmachine will recall both voltage & wire feedspeed of the active gun.
Synergic Pulse Capability when connected to Millermatic 350P. Remotely change weld output by simply adjusting wire feed speed setting at the feeder.
Patent-pending Hybrid Technology—connects to Millermatic 10-pin connector andwelding output circuit.
Polypropylene case with built-in slide rails gives you the ability to easily change wire when in vertical position.
Double-filtered gas valve helps keep dirt from clogging and affecting gas flow.
Comes standard with .035/.045reversible drive rolls.
Works with any Miller-compatible MIG gun (MIG gun sold separately)
Compatible with the following Millermatic models:Millermatic 212 Auto-Set™Millermatic 251Millermatic 252Millermatic 350P.
Extend your Millermatic work area up to 40 ft! No more moving the machine and pulling primary power cables around the shop.
Use as a dual feeder option! Keep one wire in the machine and a different wire in the feeder. No more downtime changing spools and drive rolls.
Auto-Gun Detect™ — when connected to a Millermatic 252 or 350P, simply pull thetrigger on either gun and the Millermaticmachine will recall both voltage & wire feedspeed of the active gun.
Synergic Pulse Capability when connected to Millermatic 350P. Remotely change weld output by simply adjusting wire feed speed setting at the feeder.
Patent-pending Hybrid Technology—connects to Millermatic 10-pin connector andwelding output circuit.
Polypropylene case with built-in slide rails gives you the ability to easily change wire when in vertical position.
Double-filtered gas valve helps keep dirt from clogging and affecting gas flow.
Comes standard with .035/.045reversible drive rolls.
Works with any Miller-compatible MIG gun (MIG gun sold separately)
Compatible with the following Millermatic models:Millermatic 212 Auto-Set™Millermatic 251Millermatic 252Millermatic 350P.
Check it out on www.brweldingsupplies,com
or call Bob Romero @ 800-783-3073
